Which Hole Does Hitch Hardware of Draw Tite # 24914 Install into On 2019 Mazda 3 Hatchback

Updated 05/06/2019 | Published 05/03/2019

Question:

Both your site and the Draw-tite site confirm that this hitch fits the 2019 Mazda 3 hatchback, however, after inspecting my vehicle I am not sure how this hitch will mount to the frame. It relies on the side bolts to screw into the weld nuts on the inside of the frame. My frame has the tape covered holes but does not have the weld nut on the inside of the frame. Is there an alternate installation method? Perhaps with a second set of carriage bolts?

asked by: Lawrence I

Expert Reply:

There are two holes on the side of your frame underneath the tape of your 2019 Mazda 3. You might double check to make sure you checked the correct one as it's pretty easy to mistake the wrong one. I attached a picture that shows which slot to use.

expert reply by: Jameson C