Search: 4 flat custom fit vehicle wiring   >  

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Okay Bob, so I did a bit of digging around and apparently this is a known issue that Blue Ox is aware of. The 41" distance between the mounting points is too wide and non-standard which is why your tow bars are being stretched too far.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Typically when using D-Ring adapters #BX88357 you'll have to snake some shorter cables, like #RM-910648-20 around the frame rail of the vehicle and then out to the front of the vehicle to connect to your safety cables. There's no easy…

The Mopar Recreational Flat Tow Wiring Kit part 68321424AB is required on select Jeep Cherokee's in order to activate the electronic power steering (EPS) system while the vehicle is in tow mode. This part must be obtained from the dealer but…

The best charge line kit for flat towing your vehicle is the Roadmaster Battery Charge Line Kit #RM-156-25. I have a hard time not recommending all things Roadmaster when it comes to the wiring for a flat tow system because of how much research…

As you mentioned in your question, both the Roadmaster EZ4 #RM-521567-4 and EZ5 #RM-521567-5 Base Plate Kits are confirmed to fit your 2014 Honda CR-V. The primary difference between the two models is that the EZ5 does not use a quick-connect…

We have a replacement trailer side 4-way that has a 25 foot long harness with the part #A25W2GWB.

The Optronics 4-Way Wishbone Trailer Wiring Harness #A25W2GWB that you referenced has 18 gauge wire for the ground and 20 gauge wire for all of the lighting functions. I check with all of the other wishbone harnesses that we have and they all use…

The 25 Ft 4-Way Trailer Wiring Harness #A25W2GWB uses 18 gauge wire for the ground wires and 20 gauge wires for the light functions. The Wiring is copper and not aluminum.

For your 2012 Honda CR-V, I double checked everything in your owners manual and have confirmed the Blue Ox Fuse ByPass Switch for Towed Vehicles - 2 ATM Mini-Fuse, #BX88273 is the switch you want for the two 7.5 amp fuses. They are in fact mini…

In order to flat-tow a 2014 Honda CR-V you'll need a base plate kit, tow bar, safety cables, wiring harness, and braking system. There may also be a few other smaller items for convenience. I have attached a list of these for you below.…