Recommended Trailer Hitch for a 2005 Dodge Ram 1500

Question

Question:

I only have a bumper mounted ball which I know is not good from a rating and height point of view. My question is what hitch shall I buy? A frame mounted receiver with a 2” or a 2.5” mount? a Class IV or a class V?

asked by: Duncan V

0

Expert Reply:

According to the owner's manual for your 2005 Dodge Ram 1500, if you will be towing more than 5,000 lbs but not more than 12,000 lbs then you will need to use a class IV trailer hitch with a 2" receiver tube opening. For this, I recommend the Draw-Tite Ultra Frame Trailer Hitch Receiver part # 41929 which has a maximum gross trailer weight rating of 12,000 lbs.

The Draw-Tite Ultra Frame Trailer Hitch Receiver is a custom fit for your Ram and it has a lifetime warranty. It also comes with a durable black powder coating so you should not have any issues with rust. I have attached a photo that shows what it could look like while installed.

Please note that although the hitch my be rated up to 12,000 lbs, the vehicle is likely rated for less weight so that will be your limiting factor.

expert reply by: Conner L

0

click to enlarge

Answer 1

For your 2005 Dodge Ram 1500 Rumble Bee I recommend the Curt Trailer Hitch Receiver #C15809. This is confirmed to fit the Rumble Bee and designed to install below the factory hitch. If you want to remove the factory hitch you also have that option.…

view full answer...

Answer 2

Thanks for your pictures, this helped me identify that your hitch is a factory hitch on you 2007 Ram 2500. I can tell because of the design and the way the hitch is mounted to the cross-frame with a weld. I have linked all the hitches that will fit…

view full answer...

Answer 3

If your 2007 Dodge Ram already had a 7-Way, then all you would need to do is connect the Hopkins Replacement harness, #42145, and install the brake controller and plug it in to the factory tow package plug. If your Ram had a factory 4-Way, there are…

view full answer...

Answer 4

It sounds like your 2008 Ram 1500 has a factory 4-way connector instead of the factory 7-way connector. To add a 7-way connector you will need the #ETBC7 which will plug into your 4-way connector and you will just need to make a few more connections.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Recommended Trailer Hitch for a 2005 Dodge Ram 1500

Continue Researching