Troubleshooting 40ft Gooseneck Trailer Vibrating Loaded and Unloaded
Updated 03/05/2019 | Published 03/03/2019 >
Question:
I have a 40ft gooseneck dual tandem trailer 20k suspension leaf spring , I have a vibration loaded or unloaded, I replaced all tires , bushings , and bearings , and I still have vibration anything else that can be causing vibration ?
asked by: Erick
Expert Reply:
If you are getting constant vibration when towing your gooseneck trailer then it is likely that one or more components of the suspension is in need of replacement and/or your axles are out of alignment.
Start off by checking your suspension components making sure that they are all in good working order. I have attached a link to our selection of suspension components as well as a trailer maintenance schedule for you to check out.
To determine if your axles are out of alignment you will need to measure from the end of the spindle on one side of your trailer to the gooseneck coupler and then compare that to the same measurement on the other spindle of the same axle. If these are the same then your axles are aligned but if they don't measure the same then that means they aren't aligned properly and something isn't sitting properly with your suspension.
In that case you would need to go along and measure from the various suspension components to the gooseneck coupler and compare that to the corresponding component on the other side of the trailer. Anything that doesn't measure the same needs to be fixed so that it lines up correctly.
Product Page this Question was Asked From
6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Trailer Leaf Springs
- Double Eye Springs
- 9/16 Inch Eye
- Nylon Bushing
- 4500 lbs
- 1-3/4 Inch Wide
- 6 Leaf
- 26 Inch Long
- Standard Grade
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Vibrates at Speeds Over 65 MPH, Should Tires Be Balanced
- Shop: Weigh Safe Hitch w/ Built-In Scale for 2" Hitch, 6" Drop/7" Rise, 12.5K, Aluminum
- Search Results: weigh safe trailer hitch ball mount
- Shop: Roof Rack
- Q&A: How Much Wiggle Room Should There Be In A Trailer Coupler
- Article: Where to Position the Trailer Axle?
- Q&A: Diagnosing Trailer Vibration From 65-75mph.
- Q&A: How to Adjust etrailer Weld-On A-Frame 2-5/16-Inch Coupler # CA5400
- Q&A: Troubleshooting Trailer Tandem Trailer Axles Where One Is Closer to Trailer Frame than Other
- Q&A: Troubleshooting Tandem Axle Trailer Alignment on One Side of Trailer
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Suspension Enhancement
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Search Results: trailer tires and wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Search Results: trailer hitch ball mount
- Article: How to Measure for Trailer Hitch Drop
- Shop: Base Plate for Tow Bar



