Are Load Resistors Required for all LED Replacement Lights on Truck
Updated 02/27/2019 | Published 02/26/2019
Question:
Do you have to put load resistors on all LEDS installed or just the turn signal LEDS. I want to change my tail lights, back up lights, third brake light and license plate light all to LEDS. I have a 2016 Ram 1500 Big Horn addition. I read where when ever a LED bulb was installed a resistor need to be also or you would get messages inside on your dash. Thanks for any information you can provide.
asked by: Robert H
Expert Reply:
You are going to want to use LED Light Bulb Load Resistor # DI34ZR for all the replacement LEDs you are installing on your 2016 Ram 1500.
On most vehicles what will happen is the reduced power draw of LED lights makes the vehicle think you have a burned out bulb which results in the messages on your dash you referred to; using load resistors prevents this from happening.
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Cabin Air Filter
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Shop: Fusion LED Combination Tail Light - Submersible - 4 Function - 12 Diodes - Red and Clear Lens
- Shop: Mini Clearance/Side Marker Light w/ Grommet - Submersible - Red LED - Red Lens - 9" Pigtail
- Search Results: mini led clearance light
- Video: Complete Breakdown of the TecNiq LED Trailer Tail Light
- Video: Checking Out the Fusion LED Combination Tail Light
- Video: Review of Optronics Trailer Lights - Tail Lights - OPT66KB
- Shop: Mini Clearance/Side Marker Light w/ Grommet - Submersible - Amber LED - Amber Lens - 9" Pigtail
- Search Results: trailer lights converter
- Shop: Optronics Clearance or Side Marker Light - Submersible - Incandescent - Round - Amber Lens
- Search Results: surface mount trailer lights
- Search Results: amber turn signal
- Search Results: reflective tape
- Search Results: trailer lights
- Search Results: mini led marker lights
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Bauer Products Magnetic Door Holder for Trailer Compartment Doors - 1-1/2" Diameter
- Shop: Optronics Trailer License Plate Light - Incandescent - Surface Mount - Chrome - Clear Lens
- Q&A: Recommended License Plate Light for 1-1/4 Inch Hole on Bumper
- Q&A: License Plate Light and Bracket That can be Removed
- Q&A: What is Meant by PC-Rated Trailer Lighting and When Are This Type Required
- Q&A: Are Load Resistors Always Required When Installing LED Lights As Replacements To Incandescent Bulbs
- Video: Let’s Check Out the ARC Lighting Load Resistor for LED Lights
- Video: All About the Load Resistor Kit for LED Turn Signals
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Article: Trailer Wiring Diagrams
on Accessories and Parts
