Result: surface mount trailer lights

Dielectric grease is basically just applied in a thin coating to the connector plug. You can use #11755 or #LT37534 if you prefer a smaller amount. I've attached a video to assist. Just like the connection on the back, you can add this to the…

The first thing you want to do is read the instruction manual for your brake controller. Once you have calibrated the device and understand how to make adjustments, it is time to find the best settings based on your vehicle and the trailer you are…

Hey Matt if you installed a Fusion LED Combination Tail Light Bar for Trailers Over 80" Wide #STL264RB on either side of the rear of your trailer it would work well for trailer lighting and it would be DOT compliant. This is also submergible.

I attached a chart that has all of the recommended lug nut torque specs for trailer wheels. Based on your studs being 1/2 inch, your wheels being 15 inches in diameter, and your lug nuts being coned you would want to torque your lug nuts to 90-120 ft…

The dampening is different between the higher and lower rated Curt RockerBalls. Based on your trailer being lighter I'd recommend the part #C94CR that you mentioned even though the roads you plan to travel on are rougher. This will give you the…

Yes, you can use the Reese Friction Sway control part #83660 without a weight distribution system. You would just need to use the tab part #RP26003 on the ball mount as well.

Your brake lights and turn signals for each side are on one circuit. The left side turn signal and brake light is generally the yellow wire going into your trailer connector. The first thing to do is check the fuses on your tow vehicle. Next, inspect…

Hey Dan, A 205/75R15 tire has an 8.07" width so the Trimax Trailer Wheel Chock and Lock #TMX85FR would be a compatible fit. I've attached a short video below where Adam will show you how this lock works.

Trailers use what is called a 2-wire system which means the turn signals and brake lights are on the same circuit. When you try to add separate amber turn signals you will need to separate out the brake light signal using a converter, #118158. On…

The Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV wins for ease of install and it does a really good job but if you were wanting the best sway control that applies the left and right brake assemblies independently the Tuson…

If you're experiencing sway control issues, adding a friction sway control bar could be just what you need to get things under control. I recommend the Curt Friction Sway Control part #17200. In order to install the Curt Friction Sway Control…

For your 2017 Chevy Silverado 1500 4x4, I recommend the Timbren Rear Suspension Enhancement System #TGMRCK15S. The 8600 lb rating is for just the spring's ability and they will not be used to that extent on your vehicle as other parts would fail…