Foot Plate Recommendation for Bulldog A-Frame Jack # BD155032

Question

Question:

Will this work for my top wind A frame manual jack tja-5000-b? Based on the dimensions, it should: Thanks.

asked by: Steve M

0

Expert Reply:

For your jack with part number # TJA-5000-B, the correct foot plate you'd need is the part # JF-99.

expert reply by: Jameson C

0

Answer 1

Hey Bruce, we actually have a drop leg that was designed to be used with the etrailer jack part #TJA-5000-B with the part #JF-1005H-Z but the Bulldog drop leg you mentioned would not work.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 4

Hi Dan! I have a couple potentially dumb questions. Are you sure you have a 1.5" hitch receiver? Was that measured at the inside or outside of the hitch opening? And if it is truly 1.5" for the inside of the receiver, what is this hitch on?…

view full answer...

Answer 5

No long-term contract, Natalie - but a service plan is required to use the trackers. When you buy the 3000 with wifi assist #PM84FR, 5000 #PM64FR, or 5000 with wifi assist #PM74FR from etrailer, you’re purchasing the hardware/device only. To activate…

view full answer...

Answer 6

Hey Barry! The Stealth Hitches #SH54QR will fit your 2026 Mercedes-Benz GLC 300 Coupe. This comes with a 2" receiver that has a max tongue weight of 350 lbs. This is on the difficult side for installation, especially with a Mercedes, but still…

view full answer...

Answer 7

Thanks for that photo, I do appreciate it. And all of the couplers we have - and indeed all the ones I am aware of - require a frame that is fully engaged. While Demco was not able to provide a dimensional drawing, we did measure the Demco 50-Degree…

view full answer...

Answer 8

Hey Michael, congrats on the new SUV. The EcoHitch item #EH87CR does not require you to remove the rear bumper assembly when installing. It does require some slight fascia trimming though. You'll have to remove a 2-3/4” deep and 4-1/2” wide…

view full answer...

Answer 9

Hey Al, Since your Dexter #9919860 is a 3,500lb axle you'll need grease seals #RG06-050 which come as a pair. I'd get 3 pairs (6 seals) that way you have an extra incase one goes in funky and bends (I've repacked hundreds of hubs and it…

view full answer...

Foot Plate Recommendation for Bulldog A-Frame Jack # BD155032

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching