How to Remove & Replace Factory Twist-In 7-Way Trailer Connector on 1999 and Newer Chevy/GMC Trucks

Question

Question:

How to I know if my 2011 Chevy plug is twist lock or how do I get the one out that is not working

asked by: David

0

Expert Reply:

Take a look at the video I have linked that shows installation of 7-Way trailer connector # PK11916. In this video it shows not only what the twist-in connector looks like but also how to remove it in order to replace it. If this is the type of factory 7-Way you have then # PK11916 will fit in place of the factory 7-Way.

expert reply by: Michael H

0

Answer 1

It sounds like there is a short somewhere along the wiring of your vehicle or trailer that is causing a fuse to blow every time you connect. The first thing I recommend doing is disconnecting the trailer and using a circuit tester like #PTW2993 to…

view full answer...

Answer 2

Yes, we do! The best one is going to be the No-Drill Mount for Electrical Mounting Bracket item #18140. This bracket will wrap around any hitch, square, round, OEM, or aftermarket and provide you with a mounting point that does not require drilling.…

view full answer...

Answer 3

Yes, the Custom Third Brake Light Camera for Factory Monitor part #3460015 which is a fit for a 2018 Ram 3500 will still allow you to use your factory backup camera in the tailgate. That said, you could not display both cameras at the same time so…

view full answer...

Answer 4

The duty cycle on the Firestone Heavy Duty Air Compressor part #F9499 is 30%. The flow rate of this compressor is 0-30 psi in 14 seconds and 0-60 psi in 35 seconds while using a 1/2 gallon tank. The duty cycle on the Firestone Xtreme-Duty Air…

view full answer...

Answer 5

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball mount…

view full answer...

Answer 6

Yes, there is a way to measure the fitting size to ensure it is the correct size to use with the Propane Adapter Fitting #37207-30225. The best way to do this would be to use a digital caliper like the #PTW80157. A 1/4" NPT fitting should…

view full answer...

Answer 7

Hey Dustin, The Demco Actuator #DM48CV is in fact for disc brakes and we have to get our page updated! Thank you for pointing that out so we can get that fixed haha. Since you're looking for a drum brake application the actuator you are going to…

view full answer...

Answer 8

It looks like you purchased the #A57WB, and most standard 4-Pole flat connectors will fit this 5-Pole flat connector- so you may just be able to plug it in not using the end port. However, you could also just get a new cord with a 4 flat on it with…

view full answer...

Answer 9

I would start by inspecting the connector on your trailer and the vehicle to make sure there is not corrosion in the connector which could be causing a bad or weak connection. If there is corrosion in the trailer side connector, you would need to…

view full answer...

How to Remove & Replace Factory Twist-In 7-Way Trailer Connector on 1999 and Newer Chevy/GMC Trucks

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching