Correct Tire Pressure for Trailer Tires

Question

Question:

Thanks for your response, but I only have a palomino pop up tent trailer that doesnt way very much. Does your answer also apply to this such trailer?

asked by: Maria E

0

Expert Reply:

It should be 50 psi if that is what is on your tire's sidewall; on any trailer tire you always want to inflate the tire to the maximum cold psi. Doing this will give you the best performance, allowing the tire to wear more slowly and give you optimum gas mileage.

expert reply by: Kyle S

0

Maria

7/25/2018

Thanks for your response, but I only have a palomino pop up tent trailer that doesnt way very much. Does your answer also apply to this such trailer?

Kyle S.

7/25/2018

It does still apply, even if your pop-up trailer doesn't weigh very much. The max psi that is listed on your tires is still going to be what gives you the best overall performance.

Answer 1

The Curt T-Connector Vehicle Wring Harness, #C56158, is designed to bypass pulling electric from your 2015 Honda CR-V's lighting wiring and get power directly from the vehicle's battery. The T-Connector harness includes a powered light…

view full answer...

Answer 2

First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part #PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. If the voltage…

view full answer...

Answer 3

The first thing you are going to want to do is take a circuit tester and test the red wire just before it enters the converter box. If you do not have power here then test this wire again just before the fuse holder. If still no power then there is…

view full answer...

Answer 4

If you've replaced the 10A fuse in the yellow fuse holder where the power wire for the taillight converter of the #118561 wiring harness attaches to the vehicle battery and you're still not getting any power output to the trailer, then the…

view full answer...

Answer 5

It sounds like you may have forgotten to install one of the two included fuses of the Curt Harness part #C56158. The larger fuse that goes in the red fuse holder powers the entire converter so without it the lights wouldn't function. You can test…

view full answer...

Answer 6

That's a fantastic idea! You would need to cut the wire on either side of the fuse holder and wire in enough wire to either side of it so that you could reposition it wherever you felt would be the most convenient. We sell 12 gauge wire by the…

view full answer...

Answer 7

I am sorry to hear that you are having an issue with the running light circuit of the Curt Vehicle Wiring Harness #C56158 not working on your 2013 Honda CR-V EX. It sounds like you have gone through most of the troubleshooting steps so I recommend…

view full answer...

Answer 8

Curt does a really good job on the hitch side of things but when it comes to the electronic side of things they are definitely not my first choice simply because we tend to have more issues with their wiring simply giving out like what you…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Correct Tire Pressure for Trailer Tires

Product Page this Question was Asked From

Continue Researching