No Power to 4-Way on a 2013 Honda CR-V with Curt Wiring Harness
Updated 01/21/2019 | Published 01/19/2019 >
Question:
I install the wiring harness 56158 on my CRV but there is no power to the four way. I’ve installed both fuses in the correct place. Is there anything else y’all could recommend?
asked by: Christopher
Expert Reply:
The first thing you are going to want to do is take a circuit tester and test the red wire just before it enters the converter box. If you do not have power here then test this wire again just before the fuse holder. If still no power then there is most likely an issue in the vehicle's tow package wiring and you will need to take it into the dealer to have it troubleshooted.
If you have power just before the fuse holder then replace the fuse. If you have power just before the converter box then remove the ground, pick a new spot on the body, sand down the surface thoroughly, and then reground. If this still does not fix your issues then you may have a bad converter box and the Curt T-Connector Vehicle Wiring Harness part # C56158 will need to be replaced.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: trailer wiring
- Shop: Trailer Wiring
- Search Results: kenda trailer tires and wheels
- Shop: Loadstar K399 Bias Trailer Tire - 205/65-10 - Load Range C
- Q&A: Tire Pressure Rating for Tire Size of 205/65-10
- Search Results: 4 pin connector
- Search Results: t connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Taillight Converter on Trailer Wiring Harness Not Functioning After Short Circuit in Trailer Wiring
- Q&A: Troubleshooting Trailer Wiring on a 2013 Honda CR-V that Doesnt have Power
- Q&A: Idea for Repositioning Fuse Holder for Curt Wiring Harness C56158 for Easier Access
- Q&A: Troubleshooting Running Light Circuit On Curt C56158 Installed On 2013 Honda CR-V Not Working
- Q&A: Installing the Curt Custom-Fit Wiring Harness # C56158 on a 2015 Honda CR-V
- Q&A: Replacing Curt Wiring That Blows Fuses on 2014 Honda CR-V
- Shop: Optronics LED RV Tail Light and License Bracket - Stop, Tail, Turn, Backup - Oblong - Driver Side
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: TowSmart Trailer Connector - 4-Wire Flat Set - 12" Trailer - 48" Vehicle
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Shop: Brake Controller
- Article: How to Choose the Right Trailer Hitch Class

