What is Purpose of White Wire in Wiring Kit Brake Electric Trailer Brake Controllers # 5506

Question

Question:

after watching the video installation of this kit on the Honda Odyssey I dont understand the function of the white wire of the duplex wire.

asked by: Mark W

0

Expert Reply:

The double bonded wire of the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers # 5506 that you referenced carries two circuits to the battery of the vehicle for installing the brake controller. The black wire is the power wire and the white wire is the ground circuit.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We have the Draw Tite front hitch part #65053 that fits your 2022 Ford E-450 Jayco motorhome.

view full answer...

Answer 2

The Redarc Tow-Pro Liberty #RED24FR you were looking at is a great option for your 2007 Toyota 4Runner as long as the trailer you plan on towing does not have more than 2 braking axles. If your trailer has more than 2 braking axles you will need the…

view full answer...

Answer 3

Hey David, we can help with a brake controller install in your 2006 Jeep Wrangler that has a factory 7-way but your Jeep does not have brake controller pre-wiring so you would need to hardwire in the controller with a kit like the part #5506 and a…

view full answer...

Answer 4

The Isuzu NPR models are not factory wired for an electric brake controller. If you already have a 4-way trailer connector, then you will use the wiring kit #ETBC7 to hardwire your brake controller. If you already have a 7-way trailer connector, then…

view full answer...

Answer 5

That’s actually a common and temporary side effect, Greg. Most towed vehicles store a little vacuum brake assist even after the engine shuts off. During setup, the Curt Braking System #RVi44FR removes that vacuum assist to prevent overbraking, but if…

view full answer...

Answer 6

Hey Sparky. If your 2008 Ford E-450 came with a factory 4-way connector, the factory brake controller harness is a brown 6 pin connector located behind the hood release latch up near the firewall inside the cab. There is a gray connector in a similar…

view full answer...

Answer 7

Hi James; with your 10' measurement you can use the Classic Accessories PolyPro III Deluxe RV Cover for Teardrop Trailers up to 10' Long #CA44MR. Since you're right at 10' I recommend double checking your measurement to ensure it will…

view full answer...

Answer 8

Hello Stuart, thanks for reaching out. We do have a mounting bracket that will go with the TowSmart ProClass Trailer Connector #TS59RR. Here is what I recommend: - Mounting Bracket and Installation Hardware - Pollak 7-Pole, RV-Style Trailer Connector…

view full answer...

Answer 9

I do have an option for you but we don't have any 2" ball mounts with a 1" drop exactly, that said the vehicle will likely sag a bit once coupled to the trailer so a 2" drop ball mount should work great to keep the trailer level. I…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

What is Purpose of White Wire in Wiring Kit Brake Electric Trailer Brake Controllers # 5506

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching