Recommended Metric Bolt for the Trailer Fender Mounting Brackets Part # CE26065PGA

Question

Question:

The recommended product is 3/8inch carriage bolt, but i need to finish my homemade trailer together by Thurs. Im building it out using metric since itll be hauling around a japanese sportbike. Do you know if a M10 carriage bolt would fit in this bracket and fender metioned above or would I need to go down to M8? Would the M8 fit in the square well enough to tighten a nut?

asked by: Jeff

0

Expert Reply:

The Mounting Brackets for Trailer Fender part # CE26065PGA is designed to accept a 3/8" (0.375") carriage bolt like part # LC118155 so long as the fender has square holes. If you wanted to use a metric bolt then the correct size would be an M8 as the diameter of an M8 bolt is .3150". There would be no issues using a M8 bolt with this bracket.

expert reply by: Conner L

0

Answer 1

Hi John, you did but that was six years ago and that part number with the tire mounted has since been discontinued. The answer is still the same as before, we only have them available separately.

view full answer...

Answer 2

Hey Ed, You can switch to larger tires but you would potentially need to move the fenders up to keep a minimum of 3" of clearance so that the wheels won't rub as the suspension compresses. Are you looking to just replace the tires and keep…

view full answer...

Answer 3

Hello JT, thanks for reaching out. You are on the right track with your drawing. The etrailer Single Axle Trailer Fender #HP33RR are designed to be bolted on from the top of the step onto a bracket. These specific etrailer brand fenders are a new…

view full answer...

Answer 4

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

view full answer...

Answer 5

The recommended brackets to use with the Fulton fenders part #F008551 is the #CE26061G-2. I attached a picture that shows how a customer used these brackets with this fender for you to check out as well.

view full answer...

Answer 6

When selecting the correct replacement axle for a utility trailer you will need to know both the hub face (wheel center) and spring center measurements. For example, if your current hub face measurement is 88" and you replace this with an axle…

view full answer...

Answer 7

We have the Kodiak Disc Brake Kit part #K2HR712DS which will work great for the hub/rotor parts on the 7k axles of your 2019 Grand Design Solitude. This is correct bolt pattern, capacity, and is dacromet and stainless steel so it will do a great job…

view full answer...

Answer 8

The difference between the L44649 and the L44649R is not the size of the race used as you have found. Typically the R indicates that the bearing was used in a higher capacity application. Dimensionally the bearings are the same and would take the…

view full answer...