What Race Does the L44649R Bearing Use
Updated 06/08/2015 | Published 06/06/2015 >
Products Featured in This Question
Question:
I have a L44649R bearing and a L44610 race that were used together. What race should I use? I have the R bearing and the 1.98 inch race.
asked by: Jerry
0
Expert Reply:
The difference between the L44649 and the L44649R is not the size of the race used as you have found. Typically the R indicates that the bearing was used in a higher capacity application. Dimensionally the bearings are the same and would take the same # L44610 race.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Search Results: load range d trailer tires and wheels
- Shop: Kenda 215/60-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 - Load Range D
- Q&A: Determining The Correct Reese Goosebox For A 2021 Keystone Carbon 358
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Shop: Kenda 165/65-8 Bias Trailer Tire with 8" Galvanized Wheel w/ Offset - 5 on 4-1/2 - Load Range C
- Q&A: Can Roadmaster Tow Defender be Used with Roadmaster Direct Connect Base Plate Kit
- Search Results: airlift 74000ez
- Shop: Blue Ox Off-Road Bumper Adapters for Blue Ox Motorhome Mounted Tow Bars - 1" D-Rings
- Shop: Loadstar ST185/80D13 Bias Trailer Tire with 13" Galvanized Wheel - 5 on 4-1/2 - Load Range D
- Search Results: curt trailer hitch
- Search Results: 640603315172
- Search Results: wheel spacers
- Search Results: trailer wheel spacer
- Search Results: 5x45 wheel spacers
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Mounting Bolts and Hardware for 10" Single Brake Assembly
- Shop: etrailer Hydraulic Trailer Brakes - Uni-Servo - Dacromet - 10" - Left/Right - 3.5K
- Q&A: Torque Spec for Tightening Replacement Brake Drum Mounting Bolt
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Q&A: Recommended Torque Value For Installing Brake Assembly to 3500# Axle
- Q&A: Inner and Outer Bearing and Grease Seal for Older Trailer
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground

