RoadActive Suspension Kit for 2006 Ford F-350 With Factory Overload Springs

Question

Question:

In multiple websites Roadmaster included this part is listed for my 2006 F350 with overload springs. Will this work for my 2006 F350 DRW 4X4 Cree Cab Lariat with fifth wheel hitch? Instructions show removing tabs from overload spring spacer. Etrailer web says it does not fit. I’m confused. Any help is appreciated.

asked by: Eddie

0

Expert Reply:

There is a RoadActive Suspension Kit # RAS3611-LHD, will fit your 2006 Ford F-350 with overload springs and with a fifth wheel hitch; this has been confirmed by RoadActive.

expert reply by: Kyle S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 3

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

As long as you don't have a 5th wheel or gooseneck hitch installed, then we have a Firestone Ride-Rite kit that will work for you. I recommend installing the Ride-Rite Kit, #F2445, because you can use the Ride-Rite Lift Spacers for a 6 inch Lift,…

view full answer...

Answer 6

Hello James, thanks for reaching out. The etrailer E Track Wheel Tie Down Strap w/ Roller Idler #e96HR does not come with any E-track. We have E-track available in a lot of different lengths. The best value is the etrailer Horizontal E Track #e42VR…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Paul, welcome back! Yes, the SumoSprings Solo Custom Helper Springs #SS84VR will fit with your B&W Turnoverball installed. They're in roughly the same location but this replaces the factory bump stop and won't interfere with the…

view full answer...

Answer 9

Actually, the installation you show in your photos is exactly how it's supposed to be. I checked in with one the engineering folks at SuperSprings who manufacture the #SSR-301-47-2 Rebel Sumo Springs you installed. I forwarded them your photo,…

view full answer...

Answer 10

As for comparing the Timbrens #TGMRCK15S to the Roadmaster Active Suspension Custom Leaf Spring Enhancement Kit #RAS54FR on your 2021 Chevy Silverado 1500 (4x4), the answer really depends on how much you tow or need suspension support for your Chevy.…

view full answer...

Answer 11

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

RoadActive Suspension Kit for 2006 Ford F-350 With Factory Overload Springs

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching