Aftermarket Trailer Hitch Fits for 2012 Ram 1500 with Factory Hitch  

The hitches we carry for the 2013 Ram 1500 are not also fits for a 2010 Ram 2500/3500. So for your 2013 Ram you would want the Draw Tite Hitch part #41948 as it is a Class V hitch confirmed to fit.

The Curt Class V Hitch, #C15409, that you referenced is for 3/4 and 1 ton trucks and will not fit on your 2011 Dodge Ram 1500. The Curt Class V Hitch, #C15572, is the Class V hitch that we carry for your truck, however, it will not fit on your…

I would be happy to help you. The Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers item #RM-2460-2570 you referenced fits only 3" diameter round tandem axle trailers. These axles are typically between 5,200 lbs and 7,000…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

Drilling down through the truck bed is required for the installation of any 5th wheel trailer hitch mounting kit with above the bed rails for your 2015 Ram 1500 short bed, including #DM8552030-71. But this is a 4-bolt installation kit so you would…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…