Will Timbren Springs Work With Weight Distribution Hitch on 2014 Ford F-150?

Question

Question:

Will this work wothbmu weight distribution hitch and camper. I want these for my non weight distribution trailers

asked by: Timothy B

0

Expert Reply:

Yes, you can absolutely use the Timbren Rear Suspension Enhancement System # TFR1504D on your 2014 Ford F-150 with a weight distribution hitch to pull your camper. The Timbrens will not interfere in any way with your weight distribution system as they simply sit above your truck's rear axle so you're fine using both.

expert reply by: Kyle S

0

Answer 1

The Equil-i-zer Weight Distribution with 4-Point Sway Control, like #EQ37041ET, differs from the Fastway e2 Weight Distribution with 2-Point Sway Control #FA92-00-0450, because it does utilize 2 more points of steel-on-steel friction at the head of…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 6

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

Yes, only the receiver tube opening of the Curt Trailer Hitch Receiver part #C26HR will be visible while installed on your 2017 Ford F-150. I have attached a photo of what the finished product will look like on a similar F-150 for you in addition to…

view full answer...

Answer 10

Hey Kurt, yes the correct gap for SumoSprings Solo kits like the part #SS88UV is 1/2 inch to 1 inch like you mentioned. Did you install this already?

view full answer...

Will Timbren Springs Work With Weight Distribution Hitch on 2014 Ford F-150?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching