Do Timbren Helper Springs # TDF25004E have to be Installed Facing a Certain Way

Question

Question:

Does the narrow gap face towards the outside tire or does the wide gap face towards the outside tire?

asked by: Manfred K

0

Expert Reply:

I spoke with my contact at Timbren about help springs # TDF25004E. He said that the spring can be placed whichever way makes the most contact between the bottom of the spring and the vehicle. To me in sounded like it didn't matter.

expert reply by: Michael H

0

Answer 1

The Air Lift 1000 Air Helper Springs #AL80532 for your 2017 Ram 2500 are rated for up to 1,000lbs of capacity. While they will help reduce the front sag when you are plowing a better option would be installing the Timbren #TDF25004E. These provide…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Ryan, yes the Firestone Air Bag and Compressor kit part #F24XV that you referenced is a confirmed fit for your 2026 Ram 2500 Power Wagon. Are you planning on towing a heavier trailer?

view full answer...

Answer 10

Hey Kim, thanks for reaching out. The Firestone Ride-Rite Air Bags with Easy Mount Compressor #F24XV do fit your 2020 Ram 2500 with rear coil springs, but the hang-up is the under-bed gooseneck hitch. On your truck, the air bag brackets and the…

view full answer...

Answer 11

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 12

Hey Daniel, thanks for all of the info you listed on your trailer axle. Based on seeing all of that the correct parts are what you mentioned. The brake assembly set part #23-464-465 is correct as well as the hub/drum part #42866UC3-EZ. Did you have…

view full answer...

Do Timbren Helper Springs # TDF25004E have to be Installed Facing a Certain Way

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching