Is Optronics Trailer Clearance Light # STL69RCB Sold in Pairs or Individually

Question

Question:

STL69RCB is this a set because I dont see anything that specifies its a pair or just one.

asked by: Les

0

Expert Reply:

The Sealed, Thin Line, Over 80" LED Stop/Turn/Tail Light, 3-Function, 11 Diode # STL69RCB that you referenced is a single light. If you needed a pair of these you'd have to order a quantity of two of these.

expert reply by: Jameson C

0

Answer 1

We have a wheel and tire to make up what you're looking for but we don't have it in a combo that is already mounted on a wheel. Instead you need: Westlake 235/85-16 Load Range G tire part #LHWL410 Taskmaster Steel Modular Trailer Wheel part…

view full answer...

Answer 2

Hello Leo, I checked with Optronics and there is no record of a STL69RC1PG light. What we do offer that you may have been referring to is the Thinline LED Trailer Tail Light #STL69RCB. This is a 15" Long x 1-3/8" tall tail light with stop,…

view full answer...

Answer 3

The extent of my knowledge about running LED lights at 6 volts rather than 12 volts is that the light will draw less amperage and subsequently put out less light than when the light is ran at 12 volts. For LED lights the difference in light output…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Is Optronics Trailer Clearance Light # STL69RCB Sold in Pairs or Individually

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching