Fit of Draw-Tite Class IV Part # 41943 on 2003 Ford F550 with 34-1/4 Frame Measurement

Published 08/19/2011

Products Featured in This Question

Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2"

(8)

$417.05

2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 12,000 lbs

(2621)

$22.89

Draw-Tite Ball Mount for 2" Hitches - 3" Rise, 4" Drop - 9-1/4" Long - 16K

(3468)

$58.81

2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000

(3870)

$21.41

Question:

will this hitch bolt up on 2003 F 550 cab and chassis with 34 1/4 frame w/ four rivets at the end of each rail instead of one in the center

asked by: Rodney T

Expert Reply:

The Draw-Tite Class IV Hitch, part # 41943 will fit the rivet configuration you mentioned (see figure # 3 in the instructions I have linked to). I checked with one of my contacts at Draw-Tite, who tells me that this hitch will work with the 34-1/4 frame measurement. That 1/4 inch is within acceptable tolerances, so the hitch should fit just fine for you.

You might also need the following:

Ball Mount with 3 inch rise or 4 inch drop, part # 40331
2 inch trailer ball, part # A-90
2-5/16 inch trailer ball, part # 19286

expert reply by: Mike L