Gear Repair Kits for Venture Landing Gear VMC940RB

Question

Question:

Im looking for the bevel gear replacement kit s for both legs. VMC940RB- 80730 thanks!

asked by: Jamie

0

Expert Reply:

For your Venture landing gear VMC940RB-80730 you can use lead leg gear repair kit # LC146059 and for the follow leg kit # LC146060. I confirmed with the manufacturer that these are the correct kits.

expert reply by: Adam R

0

Answer 1

For your Venture landing gear you can use #LC276602 or #LG-179015. Either one will work.

view full answer...

Answer 2

The replacement motor for your Lippert Venture VMC940RB would be the Replacement Motor for Stromberg Carlson Electric Landing Gear Set #LC196308. The Replacement Gearbox #LC276602 is correct too if you needed that as well.

view full answer...

Answer 3

While I'm not Rachel, I can tell you a compatible replacement for your landing gear motor MQ887 is the following part: - Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178

view full answer...

Answer 4

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 5

I linked the schematic diagram for Lead Jack Repair Kit #LG-146059 taken from the written instructions. The complete instructions will be sent to you in a separate link. The follow leg repair kit is part #LC146060 in case you need it.

view full answer...

Answer 6

Thanks for all the information! You are correct that is the lead leg because it is closest to the gear and the motor. However, in order to determine which replacement lead leg you need, you'll need to find the model of the landing gear on your…

view full answer...

Answer 7

The landing gear looks like a standard set based on the pictures and the dimensions you listed. The part #LC146060 would be what you need for the follow leg and then part #LC146059 for the lead leg.

view full answer...

Answer 8

I suspect that there is a gearing problem inside the landing gear legs on your Keystone Montana 5th Wheel Trailer. In order to check this you will need to remove the end cap and take a look at the bevel gears as you turn the manual crank handle. The…

view full answer...

Answer 9

Hey Johnny, thanks for reaching out! I highly recommend using the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor #LC196308 as a replacement for your 8532-07 motor. According to my research your motor is rated for 5,500 lbs so this motor will…

view full answer...

Answer 10

Since Atwood was bought out their products' discontinued replacement parts are scarce. The remaining Atwood landing gear parts we have are shown on the linked page. We do have some bevel gear kits for other jacks, such as #LC146060, but these…

view full answer...

Answer 11

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

view full answer...

Gear Repair Kits for Venture Landing Gear VMC940RB

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching