Replacement Motor for Kwikee Series 27 Electric Steps

Question

Question:

Is this the correct part to replace a series 27 motor?

asked by: Dina

0

Expert Reply:

You will actually need the Kwikee Step Motor Conversion kit # LC379145. This kit will upgrade your old style motor and control board to the new, more current style so that replacement parts are easier to find and the system will be up to date.

expert reply by: Michael H

0

Answer 1

Since you have a 2002 Eastwood Discovery with 32 Series Kwikee steps the correct replacement motor for you is part #LC379608. If you'd like to upgrade to the current style motor and control board then you can use part #LC379145 instead. Attached…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Don, yes the Dometic 411 RV Toilet part #DMC74JF would be a direct replacement for the Thetford Aqua Magic VI as they both have the same rough in measurement. Is your Thetford giving you problems?

view full answer...

Answer 10

It sure would Irene! The Dometic 411 RV Toilet item #DMC84JF would indeed be a good replacement for a Dometic 301 like item #DOM24FR. It's going to install the same way and match your current toilet flange. It'll drop right onto the flange…

view full answer...

Answer 11

Hey Jon, happy to help. Yes, I was able to find the replacement parts to #BM44YR. The 90 degree angle #BM99RR and the check valve #BM98GR have 1/2" MPT fitting that connect directly to your B&B RV Water Center. So no worries about…

view full answer...

Replacement Motor for Kwikee Series 27 Electric Steps

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching