Search: gas struts   >  

Sorry to hear that! You will want to go over to the other side and measure the one that isn't broken. If the pitch arm is 33" then you'll need the Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support…

The purple wire on Kwikee step modules does not need to be connected for it to function as this is an optional porch light switch circuit. Yours not being connected is most likely not the issue. See attached wiring diagram. In this diagram…

You will want to measure the length of your current Solera awning pitch arms and match up the correct size on the link I attached for you. Based on the photo you attached, you will likely need one of the following sizes: -Replacement Pitch Arm…

You can wire a license plate light like part #LPL55CB without running wiring up to the front of the trailer. You simply attach the white wire with the ring terminal to a clean, bare metal surface like the trailer frame, and then attach the black wire…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

It sounds like the 6K might be referring to 6,000 pounds although I cannot be 100 percent sure on that. I could tell you for sure if you could tell me the inner and outer bearing numbers stamped in to the bearings. A 7K axle will use inner bearing…

Yes, the hose outside diameter is 3 inches. The RhinoFLEX RV Sewer Hose w Swivel Fittings, 4-in-1 Adapter, and Storage Caps - 15' Long #CAM39761 with its attachments fits 3 inch slip and also 3 inch , 3-1/2 inch, and 4 inch threaded pipes.

Yes, I would recommend using a weight distribution hitch with sway control. I am a big fan of Equalizer for their reliability, ease of use, and affordability. It looks like your 2022 E2W Alta 2810KIK TT tops out at 9,597 lbs when fully loaded. Weight…

The Gas Shock #372-7901 you were looking at would attach to a 10mm ball stud, but I have no way of knowing if the shock in your photo would connect to 10mm ball without physically testing it.

There are many factors that go into selecting the correct gas shock, the easiest would be to simply match the new shock with the existing using any labels printed on the body. If none are present or you are adding a new one then you can use a formula…

You will need to select the correct strut based on the weight rating for your current struts. These struts are 36" long from center of socket to center of socket and have the 13mm sockets which are the same as your 1/2". 20LB #3691871-20…

The hinge you referenced part #PLR2212-AS would replace what you have now on your horse trailer and the holes would line up. It looks like for your window you'd need a piano hinge that's about 2 feet long, but at this time we do not have any…