Timbren Recommendation for 2016 Ram 2500 with 2,600 lb Slide In Camper

Question

Question:

I have a 2016 ram 2500 which I carry a 2600# slide in camper. Fully loaded I’m at max weight. Which Timbrens should I go with? The Commercial one? Thanks,

asked by: Bill L

0

Expert Reply:

For the weight of your slide in camper the heavier duty Timbren kit part # TDRTT3500E that you referenced would be the way to go. This can provide up to an additional 8,000 lbs of suspension support so it will work well for your application.

expert reply by: Jameson C

0

Answer 1

Hey John, thanks for getting in touch. The brackets that come with the Timbren Suspension Enhancement Kit #TDRTT3500E are custom fitted for the 2020 Ram 2500, and there is no shorter bracket we can offer for this kit. The #TDRTT3500E kit is a severe…

view full answer...

Answer 2

I would be happy to help you setup your 2022 Ram 2500 4WD with some helper springs. I recommend the SumoSprings Rebel Custom Helper Springs item #SS27GR. These springs have a 5,000 lbs capacity when they are compressed at 50%. The best part about…

view full answer...

Answer 3

If you are looking for something smaller than the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2706 to shore up the suspension on your 2018 Ram 2500 Power Wagon, you will want to look at a Timbren set up. Though I do prefer air…

view full answer...

Answer 4

The SumoSprings are definitely the best choice for your 2022 Ram 2500. The Timbren will give you a rough ride when unloaded while SumoSprings have a minimal impact on unloaded ride quality. Also, the #TDRTT3500E is a severe service kit. The only…

view full answer...

Answer 5

Hello Rustic Hart Ranch, The Timbren Severe Service kit #TDRTT3500E is a great choice for your 2021 Ram 2500 carrying that 1997 Lance Legend 500 camper. It’s specifically designed to handle heavy, constant loads like yours and really helps reduce…

view full answer...

Answer 6

The product I recommend to help with the bucking/lurching issue with your 2020 Dodge Ram 2500 is the Timbren Suspension Enhancement System - Rear Axle #TDRTT3500E.The Timbrens install in place of the factory bump stops shown in your picture.…

view full answer...

Answer 7

You will want a space between the Timbren Suspension Enhancement System - Rear Axle item #TDRTT3500E and your axle. The installation instructions call for a 1 inch gap. The only time there shouldn't be a space is when the rear of your 2022 Ram…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Timbren Recommendation for 2016 Ram 2500 with 2,600 lb Slide In Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching