Can Ultimate A-Frame Trailer Jack 322-RDJ-2K Be Completely Removed from Collar Assembly

Question

Question:

When installed will the jack slide completely out of the collar? I ask because I have a Jeep Wrangler and rear gate clearance is an issue when pulling my utility trailer. Thx

asked by: Chad P

0

Expert Reply:

Yes, the Ultimate A-Frame Trailer Jack # 322-RDJ-2K uses a separate trailer-mounted A-frame collar that allows complete removal of the jack tube from the collar. Please note that the jack ships with a black plastic wedge that is held in place with a small retaining bolt. If this bolt and wedge are removed from the jack then the entire jack can be lifted up and out of the collar to give you the clearance you need for opening the rear door on your Jeep.

Please refer to the linked photo that highlights this removable plastic wedge.

Of course, if a caster wheel like # JC-102 or a foot plate like # JF-101BK is installed on the bottom of the tube this too would have to first be removed.

expert reply by: Adam R

0

click to enlarge

Answer 1

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 6

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 7

First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…

view full answer...

Can Ultimate A-Frame Trailer Jack 322-RDJ-2K Be Completely Removed from Collar Assembly

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching