Plow and Mount Recommendation for K2 Plow on 2011 Ford F-150

Question

Question:

The k2 rampage plow are the mounting brackets included with it

asked by: Mike M

0

Expert Reply:

To install the K2 Rampage Plow part # K2RAMP8219 on your 2011 Ford F-150 you need the correct install kit for your truck. For that you'd need the part # K281521 which is the correct custom fit.

With these two part numbers you'd have everything you need to install the plow on your truck.

expert reply by: Jameson C

0

Answer 1

Hi Winston; there are two options to mount a snow plow on your 2010 Ford F-150 FX4. If you want to use the Detail K2 Summit II Snowplow #K2SUMM8826 you looked at you will need the Custom Mounting Brackets for Detail K2 Snowplows #K281521. The…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 6

Hi Stan! The SnowBear Snowplow for 2" Hitches - 82" Wide x 19" Tall #K2AVAL8219 and Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" #C31018 will definitely work on your 2013 Ford F-250 4x4. We actually have both of these…

view full answer...

Answer 7

Good question! The blade stiffeners that come with the Detail K2 Snowplow #K2AVAL8422 don't necessarily have to be used. I reached out to my contact at Detail K2 who said that the only time that those stiffeners really need to be used is if you…

view full answer...

Answer 8

Hey Gary, great question. Both plows look pretty similar huh? That is because there is only one difference between them, confirmed by Agri-cover. Agri-Cover SnowSport LT Snowplow part #SS98GV it built to be used in both the front and the rear hitch.…

view full answer...

Answer 9

We sure do! The least expensive way to add a remote controlled snow plow to your 2014 GMC Sierra 1500 is with the SnowBear Snowplow for 2" Hitches item #K2AVAL8219 and the Curt Front Hitch item #C31069. The SnowBear Snowplow item #K2AVAL8219…

view full answer...

Answer 10

Hello Donnie, thanks for reaching out. It sounds like you are looking for a snow plow for your 2013 Chevy Silverado. We do have options for this. I recommend the following: - Detail K2 Storm II Snowplow - 84" Wide x 22" Tall #K2STOR8422 -…

view full answer...

Answer 11

For your 2016 Chevrolet Silverado 1500, I recommend using the Detail K2 Avalanche Snowplow part #K2AVAL8219 with the Curt Front Mount Trailer Hitch Receiver part #C31069 in order to plow your 800' long lane. The Avalanche Snowplow is 82"…

view full answer...

Answer 12

Hello Nathan, Yes, the Custom Mounting Brackets for Detail K2 Snow Plows #K256ZR are the correct custom mounting brackets to mount your Detail K2 Snow Plows on your 2026 Ram 2500 Diesel. In order to install, MUST REMOVE DROP TUBES ON BOTTOM OF FRAME.…

view full answer...

Plow and Mount Recommendation for K2 Plow on 2011 Ford F-150

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching