Roof Vent Replacement Recommendation for 1986 Mallard RV

Question

Question:

Thanks for the response, Jameson. See attached pictures of the cover and the handle. Do you also have that tape?

asked by: Sam D

0

Expert Reply:

Email me the picture you have and I'll take a look!

expert reply by: Jameson C

0

click to enlarge

Sam D.

12/1/2017

Thanks for the response, Jameson. See attached pictures of the cover and the handle. Do you also have that tape?

Jameson C.

12/1/2017

Thanks for the picture! That is a standard style 14 inch by 14 inch RV roof vent with a fan so you can easily replace it with the Ventline # V2128SP-01 which will fit and work well as almost an exact replacement. We have the install kit part # 344270KITW which includes a sealant and screws which would work well for you. I attached an install video for this for you to check out as well.

Answer 1

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 2

Thanks for the information Eric! To replace a single wet bolt in your 2019 Grand Design Reflection 312BHTS suspension you'll need the Step Wet Bolt for 1-3/4" Double Eye Springs item #34007-187-00. This is an exact replacement for the step…

view full answer...

Answer 3

Hey Gary, welcome back! The Ventline Roof Vent item #V2128SP-01 is our only option for a 120v roof vent. It will work great with the AC power you have currently in your trailer. The Ventline item #V2128SP-01 has a manual lift that can be opened by…

view full answer...

Answer 4

All you need is a dedicated 12 volt power source to run the MaxxFan Deluxe Roof Vent #MA00-07500K. So you can run this off the 12 volt battery powered by a solar panel, as it has just a power and ground wire. The other thing you will need for install…

view full answer...

Answer 5

Yes, you can tie into the wiring from the bathroom light to install a fan for your vent. This vent fan has a switch on the assembly, so you will either have to wire into constant power before the switch to use independently or you will need the swich…

view full answer...

Answer 6

The Demco Hydraulic Brake Actuator part #DM72VR is a great option to replace an Atwood 82543. That said, it does not come with any sort of reverse lockout feature therefore in order to reverse without the brakes locking up you will either need to add…

view full answer...

Answer 7

Hi Marvin; the Replacement Printed Circuit Board for MaxxAir Manual Lift RV Roof Vents #MA10A21276K won't be any different than your current 10B21276KZ and is the correct replacement. They have updated the model number over the years as they…

view full answer...

Answer 8

Hey Mike! The etrailer Electric Trailer Jack #e55ZV would be a great replacement for the jack on your 2021 Jayco Jay Flight 242BHS. This has the same lift as your existing jack but with a higher 5,000 lb capacity making it a nice upgrade. It also…

view full answer...

Roof Vent Replacement Recommendation for 1986 Mallard RV

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching