Where Does Red Wire of Trailer Wiring Kit # 119178KIT Wire to on Vehicle

Question

Question:

Hello, I bought the upgraded tail light converter trailer harness and my question is what do I do with the red wire? P/N 119178. Thanks

asked by: William B

0

Expert Reply:

When installing the trailer wiring harness part # 119178KIT that you have the red wire gets ran to the stoplight circuit. If your vehicle has taillights that only come on with the brakes (and not with the blinkers), that is the circuit this should run to. Another place you can find this circuit is the third brake light of the vehicle.

expert reply by: Jameson C

0

Answer 1

The red wire on a brake controller signals the controller that you are stepping on the brake pedal, so it has to be connected. It does not operate the brake lights on the trailer. It attaches to the cold side of the brake switch. The brake switch is…

view full answer...

Answer 2

First, thank you for your purchases and for the opportunity to help. Auto makers do sometimes change wire colors during a production run and that is why we include the tester in the #ETBC7 brake controller install kit. You did the right thing by…

view full answer...

Answer 3

The red wire on the input side of the converter box of the Hopkins wiring kit part #40215 is the stoplight circuit. The converter box takes the wiring setup on your vehicle which has the stoplights and turn signals on different wires and combines…

view full answer...

Answer 4

The yellow wire of the 7-way harness part #H20044 that you referenced goes to the center pin of the 7-way which is an aux circuit that is typically used for reverse lights if present on the trailer. Normally the red wire on a 7-way (RV standard…

view full answer...

Answer 5

A trailer with electric brakes will require a brake controller and a 7-Way connector on your vehicle. A 4-Way will only supply the lighting on a trailer. The 7-Way is needed to power the brake controller along with the lighting. There is no straight…

view full answer...

Answer 6

I strongly recommend running the 12 volt power wire from the Curt Wiring Harness, #C59496, directly to the vehicle battery. The 12 volt accessory circuit was not designed to support the additional load of a trailer wiring harness. A wiring harness…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Where Does Red Wire of Trailer Wiring Kit # 119178KIT Wire to on Vehicle

Continue Researching