Measurements of the Lippert Components Snap Trim Screw Cover # LC326192
Updated 11/01/2017 | Published 10/31/2017
Question:
How wide is this? I need it for a starcraft trailer to cover the screw strip that holds on the door assembly. Mine blew off in the wind from highway speed. The length will be fine and the snap in part looks like it will work. Any more information you have will be helpful.
asked by: Mark Z
Helpful Expert Reply:
I went out to the warehouse to take some measurements of the Lippert Components Snap Trim Screw Cover # LC326192 for you. The overall height is 0.88 inches. On the inside, between the upper and lower lips, it is 0.75 inches.
The short lip sticks out 0.14 inches from the top edge and the top lip sticks out 0.27 inches from the top edge. I made a picture showing the measurements.
Product Page this Question was Asked From
Replacement 76" Snap Trim Screw Cover for Lippert Radius Screen Doors - Black
- RV Door Parts
- Screen Door
- Trim
- Plastic
- Black
- Lippert
more information >
Continue Researching
- Q&A: Replacement Window Seals For A CrossRoads Zinger Travel Trailer
- Q&A: Direct Replacement for Dometic Penguin II AC That Mounts from Below
- Article: How to Replace a Rubber RV Roof
- Q&A: Can Advent Air AC Unit for Dometic Kits Actually Replace a Dometic
- Q&A: Will Advent Air for Dometic Setups Work with Dometic Thermostats
- Q&A: Can Advent Air RV AC Unit Replace Dometic
- Q&A: Is There An Auto Start / Remote Start For Cummins Onan Generators? LP 5500 Gas Model
- Q&A: Replacement for 13,500 Btu Dometic Duo-Therm Air Conditioner
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Using a Portable Generator on RV
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)