Rubber Plug Recommendation for Top of Powered Lippert A-Frame Jack

Question

Question:

I am missing the rubber plug for the top of my LG jack it covers up the manual lowering screw head can you help me with a part number, price availability of this plug. my jack model is the 1817941. Thank you

asked by: Maury E

0

Expert Reply:

The 2 inch cap you are looking for for the top of your Lippert powered trailer jack is the part # LC115863.

The price and "add to cart" button are down below on this page.

expert reply by: Jameson C

0

Answer 1

If you are looking for a replacement cap that fits a 2 inch inner diameter tube you would want the part #LC115863.

view full answer...

Answer 2

We have the Lippert jack cap replacement with the part #LC115863 which fits 2 inch jack tubes like you have.

view full answer...

Answer 3

The 2 Inch Replacement Cap #LC115863 is the cap you want for a round jack with 1-3/4" inside diameter jack tube.

view full answer...

Answer 4

I went out to the warehouse and measured Replacement Cap #MJ-1500B-CP for you. The threaded part has a diameter of 2.08 inches. The overall diameter is 2.19 inches. I have included a picture showing these measurements.

view full answer...

Answer 5

We do have the cap you need, which is the Replacement Cap for etrailer and Ram Swivel Marine Jacks - 1,000 lbs #MJ-1000B-CP, which is designed for the MJ-1000B Series jacks The cap you referenced, the Replacement Cap for etrailer and Ram Swivel…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Rubber Plug Recommendation for Top of Powered Lippert A-Frame Jack

Product Page this Question was Asked From

Continue Researching