How to Remove and Reinstall the Retaining Clips on a Curt Round Bar Weight Distribution System
Updated 08/15/2017 | Published 08/14/2017
Question:
I misplaced the instructions for part #17109 Curt Spring Bar Retainer Package. Can you email them to me of tell me where to find on your website? Thanks!
asked by: Ron G
Expert Reply:
To remove the retaining clips # 17109 on a Curt weight distribution system with round bars you would first remove the bottom screws holding them on. Then you would push the clips up so the wider part of the hole can slip off the top pin.
The top pin fits into the groove in the spring bar when inserted into the head. If the pins are also being replaced pull out the old ones and then insert the new ones.
To install the clips you would reverse the above process. Check out the attached picture for more info.
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Continue Researching
- Search Results: weight distribution hitch
- Shop: Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Shop: Replacement Spring-Bar Release Clip for Fastway e2 Weight Distribution Systems with Round Bars
- Shop: Replacement Handle Spring for Convert-A-Ball Pintle Hook Combo with Balls (PH1)
- Shop: Replacement Spring Lock Kit for Blue Ox 2-Point Weight Distribution Hitch Head
- Shop: Curt MV Weight Distribution System - Round Bar - 6,000 lbs GTW, 600 lbs TW
- Shop: Replacement Head for Curt MV Weight Distribution Systems
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer tires and wheels
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: How to Choose a Trailer Brake Controller
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Search Results: trailer jack
- Shop: Brake Controller
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Shop: Base Plate for Tow Bar
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer hitch ball mount
- Video: What to Know About the Curt TriFlex NEXT Trailer Brake Controller
- Article: How to Measure Your Trailer Wheel Bolt Pattern
on Accessories and Parts
