Replacement Pads for Older J-Style Thule Kayak Carrier

Question

Question:

I have older model kayak J carriers model 853-5303 no. 18 The upper and lower pads are worn out. Wanted to know if your 6inch pad replacements are compatible with my racks.

asked by: John L

1

Helpful Expert Reply:

The Replacement 6" Pad for Thule Roof Mounted Kayak Carriers # 853-5540 will replace the old pads on your older model J Carrier. My contact at Thule confirmed this.

expert reply by: Jon G

1

click to enlarge

Answer 1

The only padded option for the larger TracRac crossbars is going to be the Thule SUP and Surfboard Pads for AeroCrossbars item #TH845000 you were looking at. These pads wrap around that crossbars and secure with some heavy duty Velcro so you…

view full answer...

Answer 2

Thanks for your business, and I did check with Thule for you, and went through each of the replacement pads for their J-style kayak carriers, and found the replacement pads are the same part number. Just keep in mind that the pads are different for…

view full answer...

Answer 3

The Replacement 6" Pad for Thule Roof Mounted Kayak Carriers #853-5540 are designed to be able to slide up and down the arm of the Thule Hull-A-Port Kayak Carrier #TH834. This was designed so that the same rack can be used on different kayaks.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Pads for Older J-Style Thule Kayak Carrier

Continue Researching