Dimensions Of Stromberg Carlson RV Exterior Ladder Rung End Cap
Question:
Will the RV ladder end cap for a Stromberg Carlson ladder 8540-CP also work on a RV ladder manufactured by Kemberly Inc.? The photograph of this part looks identical to the Kimberly part that I took off my RV.
asked by: A. J
0
Expert Reply:
I cannot confirm that the Replacement Plastic Ladder Rung End Cap on Stromberg Carlson RV Exterior Ladder - Qty 1, # 8540-CP will fit your Kemberly Inc. RV ladder. However, the rough measurements are 2 inches in length by 5/8 inch wide and 1 inch deep. With this being a contoured piece, the measurements are close and hopefully enough for you to determine if it will fit or not.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Replacement End Cap for Stromberg Carlson Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- End Caps
- Stromberg Carlson
more information >
Continue Researching
- Video: A Closer Look at the Replacement End Cap for Stromberg Carlson Exterior RV Ladders
- Shop: Replacement Endcap for Stromberg Carlson RV Exterior and Bunk Ladders - Qty 1
- Shop: Replacement End Cap for Stromberg Carlson Exterior RV Ladders - Qty 1
- Q&A: Recommended Replacement to Replace Kimberly Ladder End Caps
- Q&A: Dimensions of Replacement Plastic Endcap for Ladder Rung on Stromberg Carlson RV Ladder
- Q&A: Dimensions Of Replacement Rung for Stromberg Carlson RV Exterior Ladder
- Q&A: Replacement For 1510000236 Slide-Out Controller
- Q&A: What Can Damage The Internal Gears Of My 5th Wheel Jack?
- Q&A: Recommended Replacement For A Parallax 7345 Power Center
- Q&A: Trailer Hub Replacement for Axletek BD-65535
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: How to Replace or Install an RV Roof Vent
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)