Speed Rating of the Kenda 4.80/4.00-8 Bias Trailer Tire with 8" Galvanized Wheel

Question

Question:

What is the speed rating for kenda am30030

asked by: Steve S

1

Helpful Expert Reply:

The speed rating for the Kenda 4.80/4.00-8 Bias Trailer Tire with 8" Galvanized Wheel # AM30030 is 65 mph.

expert reply by: Scott S

1

Answer 1

We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, #CE11330, but 3/8 inch staples will work too. I would not go much shorter than the 3/8 inch staples because you don't want them…

view full answer...

Answer 2

Yes, as long as you have sufficient clearance for the larger wheel and tires you will be able to use the larger wheels. Do understand that as this is a boat trailer you will have to back further into the water with the taller tires to launch and…

view full answer...

Answer 3

Your current 4.80-8 size trailer tires have an overall diameter of just over 16-inches. The 4.80-12 size you are considering has an overall diameter of 20-1/2-inches. You will need to make sure that you will have enough clearance at the fenders for…

view full answer...

Answer 4

Based on the design of your Carolina Skiff the hook end of the BoatBuckle G2 Retractable, Ratcheting Gunwale Tie-Down Straps #IMF14221 would not be able to grab onto the sides of the boat (gunwale). But if there is somewhere else they can attach then…

view full answer...

Answer 5

Most likely the psi rating for a Load Range B 4.80x8 tire is going to be 60 psi. You will need to check the tire sidewall for the max pressure rating as it will be listed there. Trailer tires should always be inflated to their max PSI figure. The…

view full answer...

Answer 6

We have a really great option for a trailer for your 10 foot Bass Pro Pond Prowler boat, although the Malone trailer you mentioned has been discontinued by the manufacturer and is no longer available. Instead, which I highly recommend is an option…

view full answer...

Answer 7

Tire size 4.80-12 is not found on vehicles, but is a common trailer tire size on smaller utility- and sport-type trailers. In trailer use you do want to inflate them to the maximum cold psi pressure noted on the tire sidewall. Trailer tires should…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

For your 2000 Load Rite boat trailer you can replace the wheels and tires with the Kenda 4.80/4.00-8 Bias Trailer Tire with 8" Galvanized Wheel #AM30030. This uses the Kenda Loadstar K371 Bias Trailer Tire #AM10002 if you feel you will be able…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Speed Rating of the Kenda 4.80/4.00-8 Bias Trailer Tire with 8" Galvanized Wheel

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching