Replacement Amber Mini Trailer Clearance Light For Wesbar 3395

Question

Question:

Im looking for a replacement for a trailer light. It is Wesbar 3395 Amber. Do you have a product that will work? Thank you for the help.

asked by: Scott

0

Expert Reply:

We have just what you are looking for.

The replacement clearance light we offer is the Optronics Mini Rectangular Clearance Light, part # A91AB. This is an amber light that measures 2-1/2 inches long x 1-3/16 inches wide x 7/8 inch deep.

This light requires the # A91LW pigtail to complete the wiring and a mounting bracket.

The bracket is available in black, part # A91BB. For a chrome finish, use # A91CB.

expert reply by: Jeffrey L

0

Answer 1

To replace submersible lights, you will need to replace the entire unit because the light is sealed so bulbs are not accessible. You can use the Wesbar LED Trailer Clearance or Side Marker Light - Submersible - 1 Diode - Rectangle - Amber Lens…

view full answer...

Answer 2

Wesbar does not, but Optronics makes one that is virtually identical to the #W003238 that you referenced except in red. Check out the part #MC95RB. I attached a review video for this light also.

view full answer...

Answer 3

Hey Harry thanks for that! We appreciate it!

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Amber Mini Trailer Clearance Light For Wesbar 3395

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching