Dimensions of Replacement L-Pin for Fastway e2 Weight Distribution Systems

Question

Question:

What is the measurement of the square stock? what is the measurement from pin hole to bend and what is the measurement from bend to none pin hole end?

asked by: Shawn

0

Answer 1

I went out to our warehouse and measured the Replacement L-Pin for Equal-i-zer 4,000-lb Weight Distribution Systems #90-03-9460. The length of the long side is 2-1/2" long, the short side measured at 1-1/2" long and the thickness of the pin…

view full answer...

Answer 2

Hey Edmund, I went out to our warehouse and grabbed one of these L pins #FA92-03-9205 to remeasure just in case. It is that same 5/8" that you mentioned and 1.6" wide with the height being 2". Depending on what kind of tape measurer…

view full answer...

Answer 3

I reached out to Curt who informed me you will have to get a whole new weight distribution to upgrade to the Curt TruTrack 2P #C69JR. They said the Spring Bar #C86BR will not fit into your Head 17107. So you would only be able to reuse your hitch…

view full answer...

Answer 4

You are going to need a different system like the Fastway e2 Weight Distribution #FA92-00-0800 which is rated for a tongue weight of 400-800lbs and trailer weight up to 8,000lbs. The Curt TruTrack 2P Weight Distribution System #C69JR is only offered…

view full answer...

Answer 5

The Curt TruTrack 2P Weight Distribution System #C69JR is going to be to much hitch for your Forest River Cherokee Wolf Pup 16BHS. Your Wolf Pup should have around 400lbs of tongue weight while this Curt system is rated for a trailer with…

view full answer...

Answer 6

Yes, based on the weight of the Grand Design 2023 23LD that I was able to find online the Curt weight distribution system part #C69JR would work great with it.

view full answer...

Answer 7

Any time you are towing a trailer that has a fully loaded weigh that is over 50 percent of the vehicle's gross weight, a weight distribution system is recommended. If your vehicle weighs less than 6,000 lbs, a weight distribution system and…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Dimensions of Replacement L-Pin for Fastway e2 Weight Distribution Systems

Product Page this Question was Asked From

Continue Researching