Dimensions Of Crank Handle On Trailer Valet 5X
Updated 07/26/2016 | Published 07/25/2016
Question:
I would like to install a trailer valet 5x on my 2009 palomino yearling camper, but I will need to install itclose to to the camper because of the placement of the gas cylinder picture attached. I have enough space on the frame for the mounting plate but am concerned that the top wind jack crank handle will not have room to rotate 360 degrees without hitting the camper. The camper also slants out so the higher the handle , the less room to rotate it. What would be the height above the frame of the top wind crank handle, and what is the length of the handle?
asked by: Bruce W
Expert Reply:
I went to our warehouse and took some measurements of the Trailer Valet 5X, part # STC-V211 for you.
I have attached a photo of the # STC-V211 with the dimensions noted. From the top mounting bolt on the mounting bracket to the top of the handle it measures 9-1/2 inches. From the top of the mounting bracket to the top of the handle it measures 8-1/2 inches. From the center of the crank handle where it attaches to the top of the jack to the outside edge of the crank handle, it measures 8 inches. You can check to see if this allows you enough clearance form the hull of your boat and work for you.
Product Page this Question was Asked From
Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 5,000 lbs
- Trailer Dolly
- Manual Dolly
- 5000 lbs
- 15 Inch Tall
- Trailer Valet
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: trailer valet
- Search Results: trailer valet 5x
- Search Results: ark jack
- Q&A: Extreme Off-Road Swing-Up Jack for a T@B 400 Tear Drop Trailer
- Shop: Ark Xtreme Off-Road Jack w/ Dual Wheel - Sidewind - 10" Lift - 1,100 lbs - Silver
- Video: Review of Trailer Valet Trailer Jack - Drill Powered Sidewind Jack - TV86FR
- Shop: Trailer Valet JXS Drill Powered Swivel Jack w/ Wheel - 14" Lift - 1,600 lbs
- Q&A: Dimensions of Ark XO350 and XO750 Mounting Plates
- Shop: Ark Xtreme Off-Road Swivel Trailer Jack w/ Dual Wheel - Sidewind - 7" Lift - 770 lbs - Silver
- Video: What to Know About the Ark Xtreme Off-Road Jack w/ 2 Wheels
- Q&A: Will Trailer Valet JXS Jack Fit on Same Mount as Trailer Valet 5x Swivel Jack
- Q&A: What Is The Overall Retracted Length Of The ORJW350D Ark Off-Road Jack
- Q&A: Mounting Bracket Bolt Hole Dimensions of the Extreme Off-Road Trailer Jack w/ Dual Wheels # ORJW500D
- Search Results: pipe mount trailer jack with wheel
- Search Results: pipe mount jack
- Search Results: pipe mount swivel jack
- Search Results: trailer valet trailer jack
- Shop: Round Pipe Mount Swivel Trailer Jack w/ Footplate - Topwind - 10" Lift - 7,000 lbs - Weld
- Q&A: Outer Diameter of Weld-On Pipe Coupling on Trailer Valet JX Trailer Jack
- Video: Review of the Ark Xtreme Off-Road Ratcheting Jack w/ 2 Wheels
- Video: A Closer Look at the Trailer Valet JXS Drill Powered Swivel Trailer Jack with wheel
- Video: Review of the Ark Xtreme Off-Road Ratcheting Jack w/ Wheel
- Shop: Jack Foot for XO750 Series Ark Xtreme Off-Road Swivel Trailer Jack - Black
- Q&A: Trailer Jack with Drive Wheel Recommendation for Moving Sailboat Trailer
- Shop: Ultimate Trailer Jack - Sidewind - 15-1/2" Lift - 1,500 lbs
- Shop: Dutton-Lainson Pipe Mount Swivel Trailer Jack with Foot - Topwind - 10" Travel - 2,000 lbs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: How to Choose a Trailer Brake Controller
- Shop: Trailer Hitch
- Shop: Trailer Wiring
on Trailer Dolly
