How to Remove and Reinstall the Retaining Clips on a Curt Round Bar Weight Distribution System
Published 05/05/2016
Question:
How do you remove and reinstall the retaining clips on a curt distribution hitch
asked by: Ron M
0
Expert Reply:
To remove the retaining clips # 17109 on a Curt weight distribution system with round bars you would first remove the bottom screws holding them on. Then you would push the clips up so the wider part of the hole can slip off the top pin.
The top pin fits into the groove in the spring bar when inserted into the head. If the pins are also being replaced pull out the old ones and then insert the new ones.
To install the clips you would reverse the above process.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: curt 17063
- Video: Review of Blue Ox Replacement Spring Lock Kit 2-Point Weight Distribution Hitch - BLU26XR
- Video: Review of the Replacement Round Bar Retainers for Curt MV Weight Distribution Systems
- Shop: Replacement Spring Lock Kit for Blue Ox 2-Point Weight Distribution Hitch Head
- Shop: Replacement Round Bar Retainers for Curt MV Weight Distribution Systems
- Shop: Replacement Head for Curt MV Weight Distribution Systems
- Shop: Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Q&A: How to Remove and Install the Spring Clip for a Fastway e2 WDS
- Q&A: How to Remove Round Spring Bars Stuck on Head of Fastway e2 Weight Distribution System
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: Is the 15K Btu GE Appliances Deluxe Plus RV AC the Same as AR15AACW
- Q&A: Replacing Lippert 3,500 Pound Axle with 76 Inch Spring Seat Length
- Q&A: Recommended 7-Way To Hopkins Molded Trailer Wire with Different Colors
- Q&A: How to Determine What Generation of MORryde Steps You Have?
- Q&A: Availability of Weight Distribution for 1-1/4 Inch Receivers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Installation Tips