Availability of Lippert # LC241844 Replacement Landing Gear Leg

Question

Question:

Do you have a replacement electric leveling leg for an LCI Part # 241844 17inch HD rear jack on a six jack leveling system Thanks

asked by: Gord W

1

Helpful Expert Reply:

We do indeed offer the replacement leg you mentioned as part # LC241844.

expert reply by: Mike L

1

Answer 1

Hey Norman, Unfortunately that 15x6 Bobcat wheel has been in a phase out status, meaning Lionshead is no longer making them in that size so it is hard to find them. We no longer carry it and since we are not getting new stock we won't have them.…

view full answer...

Answer 2

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 3

The correct replacement converter for your Parrallax 7300 Model 7355 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp #PD4655V. This is an exact replacement but it only comes as a full assembly, you can not…

view full answer...

Answer 4

You are correct that the Reese Electric 5th Wheel Landing Gear Set - 8,000 lbs #RP500708 should drop right into place where your Lippert Venture landing gear was. These will support 4,000 lbs each, which is definitely enough capacity for your…

view full answer...

Answer 5

For the driver leg part #LC241846 that you have the correct repair kit you'll want is the #LC146059.

view full answer...

Answer 6

You'll need a new jack leg based on what you described. For a replacement you'd want the part #LC241845 for the driver side or part #LC241846 for the lead leg that is normally on the passenger side.

view full answer...

Answer 7

If your landing gear leg (inner or outer leg) is bent then I strongly advise replacing it. A bent leg can be an indication of other unseen damage. We have numerous replacement legs available for both the lead leg and the follower leg. But it depends…

view full answer...

Answer 8

Yes, the jack leg part #LC241846 that you referenced does measure 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 9

The type of noise you describe does suggest a mechanical issue in the gear train of your landing gear. Since you already replaced the gearbox this tends to point to the internal parts of the lead leg. Since it sounds like the motor itself still…

view full answer...

Answer 10

Yes, the outer tube of the replacement landing gear jack part #LC241846 that you referenced is 29-1/2 inches. The distance from inside to inside of the weld stops is 15-1/2 inches.

view full answer...

Answer 11

Hey Tom, so the Replacement Heavy Duty Driver Leg for Lippert Ground Control 2.0 Landing Gear #LC241846 that you referenced is a part we get directly from Lippert and not a licensed replacement from a different brand or anything like that. It will…

view full answer...

Answer 12

The difference is the height; the Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg #LC179013 and Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2" #LG-179013 is the lengths. The Stromberg-Carlson…

view full answer...

Availability of Lippert # LC241844 Replacement Landing Gear Leg

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching