What are Dimensions of Lippert Jack Leg # LC241846

Question

Question:

Size of tube of jack Jack tube dimensions is it 2.5 inches

asked by: Ike C

0

Expert Reply:

Yes, the jack leg part # LC241846 that you referenced does measure 2-1/2 inch by 2-1/2 inch.

expert reply by: Jameson C

0

Answer 1

You are correct that the Reese Electric 5th Wheel Landing Gear Set - 8,000 lbs #RP500708 should drop right into place where your Lippert Venture landing gear was. These will support 4,000 lbs each, which is definitely enough capacity for your…

view full answer...

Answer 2

For the driver leg part #LC241846 that you have the correct repair kit you'll want is the #LC146059.

view full answer...

Answer 3

You'll need a new jack leg based on what you described. For a replacement you'd want the part #LC241845 for the driver side or part #LC241846 for the lead leg that is normally on the passenger side.

view full answer...

Answer 4

I attached a diagram that shows how the Lippert Components Venture Lead Leg Repair Kit #LG-146059 installs.

view full answer...

Answer 5

The difference is the height; the Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg #LC179013 and Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2" #LG-179013 is the lengths. The Stromberg-Carlson…

view full answer...

Answer 6

There really isn't a difference between the #LC119101 and #LC179014. One is just listed for Venture landing gear sets and the other Lippert. They are both identical though.

view full answer...

Answer 7

We do indeed offer the replacement leg you mentioned as part #LC241844.

view full answer...

Answer 8

The type of noise you describe does suggest a mechanical issue in the gear train of your landing gear. Since you already replaced the gearbox this tends to point to the internal parts of the lead leg. Since it sounds like the motor itself still…

view full answer...

Answer 9

I spoke with my contact at Lippert Components about what the correct replacement bevel gear kit would be for the front landing gear on your 2017 Open Range Roamer 371MBH. He said that the front landing gear for the Ground Control 2.0 actually…

view full answer...

Answer 10

Hey Tom, the Replacement Heavy Duty Driver Leg part #LC241846 that you referenced is a lead screw type as it does not have any bearings.

view full answer...

Answer 11

Yes, the outer tube of the replacement landing gear jack part #LC241846 that you referenced is 29-1/2 inches. The distance from inside to inside of the weld stops is 15-1/2 inches.

view full answer...

Answer 12

The correct landing gear leg replacement for the Lippert Ground Control 2.0 that you have is actually the part #LC241846. We have no way of knowing if the #LG-179013 could work for you since it's never been tested although I can see how it looks…

view full answer...

What are Dimensions of Lippert Jack Leg # LC241846

Product Page this Question was Asked From

Continue Researching