Repair Kit Recommendation for Lippert Landing Gear Jack # LC241846

Question

Question:

Can you please tell which jack repair kit will work for part 241846. It is the Lippert system but leg says venture. I need a few of them.

asked by: D H

0

Expert Reply:

For the driver leg part # LC241846 that you have the correct repair kit you'll want is the # LC146059.

expert reply by: Jameson C

0

Answer 1

We sure do Billy! That 241846 part number you gave me corresponds to the Replacement Heavy Duty Driver Leg for Lippert Ground Control 2.0 Landing Gear item #LC241846. The item #LC241846 is intended to replace the heavy duty master leg on Lippert…

view full answer...

Answer 2

You are correct that the Reese Electric 5th Wheel Landing Gear Set - 8,000 lbs #RP500708 should drop right into place where your Lippert Venture landing gear was. These will support 4,000 lbs each, which is definitely enough capacity for your…

view full answer...

Answer 3

You'll need a new jack leg based on what you described. For a replacement you'd want the part #LC241845 for the driver side or part #LC241846 for the lead leg that is normally on the passenger side.

view full answer...

Answer 4

Based on your description it sounds like you need a replacement motor for your landing gear. The correct replacement for your 1RV-200 is the #LC142178. If you need a replacement gear box as well then you can use the #LC276602.

view full answer...

Answer 5

Thanks for the picture! We sure do! You will want the Replacement Motor for Stromberg Carlson Electric Landing Gear item #LG-142178.

view full answer...

Answer 6

If the bevel gears/gearbox for the dual-motor landing gear on your 2011 Keystone Laredo 266RL 5th wheel were badly worn or damaged you would most likely be able to hear it. These conditions typically cause a good bit of noise as the jacks try to…

view full answer...

Answer 7

That is a Venture/ADTH motor and gear box, and what you use to replace it is a motor and gear box from Stromberg Carlson, which are the following part numbers: - Replacement Motor #LG-142178 - Replacement Aluminum Gearbox #LG-179015

view full answer...

Answer 8

The correct replacement motor is part #LG-142178, and the Replacement Aluminum Gearbox, #LG-179015. The correct replacement switch is the part #LG-145236.

view full answer...

Answer 9

It sounds like the landing gear leg in question may have been over extended. If the leg seems to be slipping and has trouble extending (but you can still hear the motor turning) then this is likely what happened and it probably damaged/stripped the…

view full answer...

Answer 10

I attached a diagram that shows how the Lippert Components Venture Lead Leg Repair Kit #LG-146059 installs.

view full answer...

Answer 11

We do indeed offer the replacement leg you mentioned as part #LC241844.

view full answer...

Answer 12

If your landing gear leg (inner or outer leg) is bent then I strongly advise replacing it. A bent leg can be an indication of other unseen damage. We have numerous replacement legs available for both the lead leg and the follower leg. But it depends…

view full answer...

Repair Kit Recommendation for Lippert Landing Gear Jack # LC241846

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching