Replacement Trailer Clearance Light Lens for SAE-A-P2-83

Question

Question:

Im looking for 2 orange light covers for my viking pop up camper....its for the front 2 on each side.....part # for these covers is SAE-A-P2-83...Im not having any luck finding what Im looking for....can u help? Thank you,

asked by: Mike C

0

Expert Reply:

Normally we can't look up replacement lenses by the SAE number, but I was able to determine that you are looking for the part # 34-59-012.

expert reply by: Jameson C

0

Answer 1

If you are looking for a red lens for your Bargman 59 Series light you would want part #34-59-010, if you need an amber lens you would need part #34-59-012.

view full answer...

Answer 2

You will need to do some measuring to determine if you will need an adapter with offset or not, or if you will even be able to tow a 5th wheel trailer with your gooseneck hitch. Here is how to determine if an offset would be required. First, measure…

view full answer...

Answer 3

Yes, the replacement lens #34-59-012 that you referenced will fit the Bargman Series 59 LED clearance taillights.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Replacement Trailer Clearance Light Lens for SAE-A-P2-83

Continue Researching