Availability of Replacement For National 442109 Grease Seal

Question

Question:

do you have trailer grease seal,s national seal,s#442109

asked by: Nelson H

0

Expert Reply:

The TruRyde # GS-2250DL cross references to the National 442109 grease seal. The # GS-2250DL has an inside diameter of 2.250 and an outside diameter of 3.376 inches, and is a compatible replacement for your National grease seal.

expert reply by: Mike L

0

Answer 1

The P-29 number you're seeing on your Dexter Axle is actually the number for the plant that made the axle. There should be a stamp or sticker on your trailer frame near the coupler that shows what the axle capacity is, and if you can't find…

view full answer...

Answer 2

That's a good question, because working load limits (WLL) can be somewhat confusing, but I can explain it for you. The 9,200 lb WLL of the Titan Chain Ratcheting Load Binder for 3/8" - 1/2" Thick Chain #TCRB10 simply means that the…

view full answer...

Answer 3

The right and left orientation is determined if you are standing behind the trailer looking towards the tow vehicle. The left side is the drivers side and the right side is the passengers side. Tthe shorter brake pad will always be in the front of…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Availability of Replacement For National 442109 Grease Seal

Product Page this Question was Asked From

Continue Researching