What Do the Connectors of the # 118415 Plug Into When Installing on Hyundai Santa Fe
Published 09/11/2015
Question:
There two connectors coming off of each side of the bundled wires. A female and a male. The video only shows connecting to the female. Where does the male connector go?
asked by: Steve K
0
Expert Reply:
The reason the connection you mentioned wasn't shown in the attached video is because the factory connector that male side of the # 118415 plugs into is behind the panel of the vehicle which makes filming it difficult.
Basically you will unplug the factory taillight harness of your vehicle and then will install the connectors of this harness in between them.
You can see it better in the install instructions link I attached.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Q&A: Trailer Wiring Harness Options for a 2011 Hyundai Santa Fe
- Shop: Vehicle Tow Bar Wiring
- Q&A: Trailer Wiring Recommendations for a 2011 Hyundai Santa Fe
- Shop: T-One Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Video: Let’s Check Out the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package-C56346
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Q&A: What Color Trailer Wires go to the Red, Black and White Taillight Wires