Placement of Rear Jacks in Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
Updated 08/03/2015 | Published 08/01/2015
Question:
I have a 32foot rig that has a 6inch I-beam frame with the entrance door behind the real tires. Installation of the rear jacks would likely need to be 3foot or 4foot behind the rear tires rather than the 1foot indicated in the install instructions. As a result, knowing how far below the frame the retracted jack hangs below the frame is critical. I do see in description that the jack travel is 12.5 so Im assuming the top of the jack motor to the retracted jack pad must be at least a few inches more than the travel. Thanks
asked by: Scott K
Expert Reply:
For the rear jacks in Lippert Ground Control 3.0 # LC358590 the bracket the jacks attach to have multiple holes and you will need to mount them so that when fully retracted the jacks have 7 to 9 inches clearance from the bottom of the foot to the ground. Overall height when retracted is closer to 24 inches.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Search Results: lippert camper jacks
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Installation - 2020 Forest River Ch
- Video: How to Install the Lippert Ground Control 5th Wheel RV Leveling System - 2015 Forest River Vengeance
- Search Results: 50 amp breaker
- Search Results: 50 amp fuse
- Shop: Circuit Breaker - 50 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Plastic - Type I
- Shop: Derale Automatic Resetting Circuit Breaker - 50 Amp
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Can Rear Jacks of Lippert Ground Control be 24 inches From Rear Axle
- Q&A: Installation Of The Lippert Ground Control 3.0 Jack Leg Mounting Brackets
- Q&A: Clearance Required Around Rear Jacks of Lippert Ground Control 3.0
- Q&A: 6 Point Automatic Leveling System Recommendation 2010 Keystone Montana Fifth Wheel
- Q&A: How to Determine if Lippert Ground Control 3.0 Will Fit 5th Wheel RV
- Search Results: trailer hitch
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer jack
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Video: How to Choose a Trailer Brake Controller
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Suspension Enhancement
