Solution for Mounting Rear Jacks of Lippert Ground Control Where There's Interference on RV Frame
Updated 05/05/2021 | Published 05/04/2021
Question:
I have checked all the locations for the mounting of the rear jack brackets and 3 of the 4 are no problem. The 4th one has a slide gear drive bar that passes through the area for the bracket. Can the bracket be modified to allow the bar to pass through? I have attached a picture of the frame mounting location. 2008 Keystone Everest 6 pt. LCI part # LC675817
asked by: Scott S
Expert Reply:
We've spoken with Lippert in the past about alternate mounting locations for the rear jacks if there is anything that would interfere with the recommended dimension. Here's what they told us as far as where you can mount the jacks on the frame:
If the customer was to take a string from the bottom of the rear most tire and run it to the bottom of the rear bumper, the jack would need to be above that line. As long as the jack is above this line, then yes they can install that far back. If any part of the jack will be below that line, they can not install it that far back.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Search Results: lippert camper jacks
- Video: How to Install the Lippert Ground Control 5th Wheel RV Leveling System - 2015 Forest River Vengeance
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Installation - 2020 Forest River Ch
- Search Results: 50 amp breaker
- Search Results: 50 amp fuse
- Shop: Derale Automatic Resetting Circuit Breaker - 50 Amp
- Shop: Circuit Breaker - 50 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Plastic - Type I
- Q&A: 6 Point Automatic Leveling System Recommendation 2010 Keystone Montana Fifth Wheel
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Can Rear Jacks of Lippert Ground Control be 24 inches From Rear Axle
- Q&A: Installation Of The Lippert Ground Control 3.0 Jack Leg Mounting Brackets
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Attaching Lippert Ground Control Middle Jacks to 2017 Laredo 342RD
- Q&A: Can the Rear Jacks On the Lippert Ground Control Be Installed With More Than 7" Clearance
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer tires and wheels
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: How to Choose a Trailer Brake Controller
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Search Results: trailer jack
- Video: B&W Companion OEM 5th Wheel Hitch Manufacturer Breakdown
