Flexible Brake Line Needed for Titan Replacement Master Cylinder Assembly # T2374600

Updated 06/24/2015 | Published 06/22/2015

Products Featured in This Question

Replacement Master Cylinder Assembly for Dexter Model 10 and Model 20 Brake Actuators - Drum

(158)

$283.54

Hydrastar Hydraulic Brake Line Kit - Tandem Axle - 25' Long, 3/16" Main Line

(39)

$264.11

Dexter Hydraulic Brake Line with Fittings - 25" Long

(66)

$64.64

Question:

Hi There, I was hoping someone there could answer a question I have.Im replacing my worn out Titan model 10 master cylinder with a new one and read on your site that a flexible brake line is required when connecting the brake line to the master cylinder/or office.The trailer I have was used when I purchased it and I noticed that a regular brake line was attached directly to the orofice.I was hoping to see if you could help me with where I could obtain this brake line with the proper sized connectors.Is it something you have?My boat trailer is for a 29foot boat that weighs around 10,000 lbs.. I would appreciate any help you could give me. Sincerely,

asked by: Craig L

Helpful Expert Reply:

If you are just looking to replace the brake line from the master cylinder to your steel brake lines, you can use Titan Hydraulic Brake Line with Fittings, # T0980100.

If you would like to replace all of the lines from master cylinder to brakes, take a look at HydraStar Hydraulic Brake Line Kit, # HS496-252. I have included a snapshot to illustrate what is included in the kit. As you can see in the picture, you will have enough brake line to go 27-1/2 ft back from the master cylinder which should be sufficient to reach the rear brakes on your boat trailer.

expert reply by: Leah S