How to Trim Plastic Fascia for Hitch Ball Installation on Silverado 1500 OEM Step Bumper
Updated 06/22/2015 | Published 06/20/2015 >
Question:
Hello- I have a 2015 Silverado 1500 WT that I would like to mount this trailer hitch ball to the rear step bumper OEM beam. Any thoughts or suggestions on how to cut through the one piece step pad facia that covers the mounting shaft hole? There looks to be a faint circle 2 1/4inch diameter? and I assume that the cut hole should be bigger than hitch ball base. Thank you-
asked by: Old D
Helpful Expert Reply:
To install a hitch ball with a 1-inch shank, such as the Curt 3500-lb-rated 1-7/8-inch ball # C40017, you'll want to start by making a 1-inch hole in the plastic fascia using a drill bit. Initially you will want the hole to be only as large as needed to match the diameter of the shank of the hitch ball you're using. Start out with just the 1-inch diameter to accept the ball's shank, then enlarge the hole using a hole saw of the appropriate diameter to match the ball's base diameter.
Product Page this Question was Asked From
1-7/8" Hitch Ball - 1" Diameter x 3" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome
- 3500 lbs GTW
- 1-7/8 Inch Diameter Ball
- 1 Inch Diameter Shank
- CURT
more information >
Continue Researching
- Search Results: curt drop hitch
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Video: Installing the Curt Trailer Hitch Receiver on your 2015 Chevrolet Silverado 1500
- Video: Stealth Hitches Manufacturer Breakdown
- Q&A: Torque Spec For Brophy 2" Hitch Ball
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Replacement 2" Receiver Attachment for Stealth Hitches
- Shop: Ball Mount for Stealth Hitches Hidden Receiver Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Trailer Mate Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Install Instructions for Trailer Wiring for 2019 Toyota Rav4
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Installing the Curt Trailer Hitch Receiver on a 2025 Toyota RAV4
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: How to Choose the Right Trailer Hitch Class
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Brake Controller
- Search Results: trailer hitch ball mount

