Availability of Wiring Harness for 2013 Volkswagen Tiguan

Question

Question:

Was told my 2013 vw Tiguan is not compatible with eTrailer wire harness. Electrical error codes will appear due to voltage of the trailer lights.

asked by: Mel

0

Expert Reply:

There is one confirmed fit for a 4-pole trailer wiring harness for your vehicle and it is the custom harness # CU26FR by Curt. This T-connector plugs directly into existing wiring. It has a powered converter that reduces strain on the wiring system and is made using SMT to ensure superior performance. I have included a FAQ article to help with the wiring.

expert reply by: Chris O

0

Answer 1

Hello Robert, thanks for reaching out. The U-haul trailers use a standard 4-flat trailer plug. We do have a 4-flat wiring harness that will work on your 2014 Volkswagen Tiguan R-Line 4Motion. We actually have two options, one from Curt and another…

view full answer...

Answer 2

You are correct, there is some trimming required on the rear fascia on a 2012 Volkswagen Tiguan to install a trailer hitch like #36474. The area that needs to be trimmed is shown in the isntructions I have linked and I have also included a picture…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...