2015 Jeep Cherokee Vehicle Engine Heaters

For your 2018 Toyota RAV4 with the 2.5L I4 engine the Kat's Heaters Custom Fit Engine Block Heater #KH11813 will work perfectly. This cartridge heater will clip right into the cavity of your engine block and submerges in the…

I really wish we had the chance to install the Kat's heater #KH13150 so we could provide an install video or pictures but the best is the following written instructions: To install the heater you will first need to drain the…

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed…

According to manufacturer's application guide your 2018 Toyota RAV4 LE with a 2.5L 4-cylinder engine would need the Kat's Heaters Custom Fit Engine Block Heater #KH11813 and it would need to be installed in…

I checked with Kat's and the Kat's Heaters Custom Fit Engine Block Heater #KH11813 that fits your 2013 Lexus RX 350 will install in the left front position, as indicated in the cut out of the manual I attached.…

I checked with Kat's and the correct Kat's Heaters Custom Fit Engine Block Heater for a 2019 Kia Sportage with 2.0 or 2.4 engine is part #KH11812.

The underside of the standard 2023 Hyundai Elantra is different than the hybrid model of the 2023 Hyundai Elantra Hybrid, which is why the #DT75MR won't fit. There is a hitch designed specifically for the hybrid which has different…

Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.

The foam ring on the Ventline Vanair Trailer Roof Vent part #VP-543SP is a weather seal that is used to help seal the dome on the fan assembly. If you continue to use the fan without the foam ring you would be subjected to leaks which could then…

As long as you have found the correct hole in your 2015 Toyota Tacoma the Kat's heater part #KH11813 would be correct for it and should slide right in. Since the hole is somewhat difficult to access you are most likely not angling it…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The…

Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…