...Hi, etrailer recommends to using Deka 10-2 gauge wire for running electric brakes to a tandem axle trailer. If this is the case, why does 7-way harnesses with molded plugs only have 12 gauge wiring...
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
...a 10 gauge power wire like item # 10-1-1 from the 12 volt auxiliary terminal on the 7-Way trailer connector on the trailer to the positive terminal on the trailer battery and ground the negative terminal...
Hey Michael, thanks for reaching out! The Dexter Nev-R-Adjust Electric Trailer Brakes #23-468-469 are an excellent choice, and will pair nicely with the Dexter Trailer Hub & Drum Assembly #84546UC3-EZ. This hub and drum comes pre-greased to…
Hello Rene, thanks for reaching out. It is pretty typical for RV manufacturers to use axles that are not rated for the full GVWR. They say this is because 10%-15% of the camper weight is on the hitch instead of the axles. They will put the bare…
Hi Shawn! I was able to find a little info on the Binkley 48000 SL you need to replace, and it looks like the etrailer Square Jack w/Handle - Foot Lever - Drop Leg - Spring Return - 12K Lift - 26.5" Travel #TJDDP-20000SP-F will be a pretty close…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
Hi Ben; the difference in the drum size won't make a difference as long as you have a #84 spindle with #L68149 inner and #L44649 outer bearings. The #AKHD-545-35-EZ-K is 10" x 2-1/2" while the #84546UC3-EZ is 10" x 2-1/4" and…
Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Filters
